Here's my old nozzle mod...for the unitiated hehe...this mod will solve the air leaks on the nozzle area...it's a cheap alternative especially for hard to find air sealed nozzles upgrades for m14, g36, sig 552 etc.
http://www.airsoftfaqs.com/technical-tips-...l-nozzle-2.html



Now here's some further improvement for it.
Mounted inside a hand drill and using a very sharp cutter just crater cut the base of the nozzle
so a 1x3 or 1x4 oring will be more deep inside the nozzle base.
Use sand paper to make the crated part more smoother and it will
help stick the small oring much better using mighty bond or any
other better bonding agent.

With this technique the nozzle will sit properly way back the cylinder head's
gas tube during draw stage
which help avoid any misfeed issues if
there are some using this nozzle mod.

Don't forget to break it in first once fully lubricated
using silicone oil by simply moving it back and forth
until it feels loose or not too tight anymore.

Nice!!! Mas ok ata to kesa dun sa nauna komrad rambo 1 question lang po, san pa nakaka kuha nang ganyang klaseng o-ring kamukha nung ginamit nyo?

galing talaga nang Pinoy!

Dacal pung salamat!

nicety !!! da doktah of a million tweaks does it again !!!



buti ka, hindi pa pasmado at tunay na matiyaga

myself, i would use the smallest round-head cutter on my rotary tool to do that

Thanks for sharing Doki!

Hehe salamat Papa Zen and Papa Jojo!!!...as well to Komrad Chicane kabalen ku ken hehe!!!!
ALam nyo naman idol ko din kayo!!!

Komrad Chicane try mu mantun oring keng airgun store, refrigeration or airconditioning shop, or even auto supply.

Yung mga 1x3 or 1x4 oring nakuha ko yan sa Simplex Binondo.
medyo mahal nga 30 petots each minsan may 20.

Very nice spending time and effort on doing that. Cheap alternative works.

will try the mod this friday.. humiram pa ako ng mini drill.. pede na ata yung pang pambutas ng PCB na drill..

yeah basta pasok yung nozzle sa drill puyding puydi yan.